The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.
FEATURES
Sliding table with 4-foot stroke works with miter head, hold-down and fence to accomodate everything from multiple end cuts to tenonsFully adjustable fence with dual digital readout for fast, accurate set-up and repeatabilityLarge table with built-in slider with room for stock feeder
7" vertical spindle travel allows stacked tooling| Spindle tilts negative 5° to positive 45° for increased versatility |
1791284 : TS29 Shaper, 7-1/2HP 3PH 230/460V with Sliding Table
| Specification | Value | |
|---|---|---|
| Part Number | 1791284 | |
| Spindle Speed | 3000, 4000, 6000, 8000 and 10,000 RPM | |
| Reversable | Yes | |
| Spindle Diameter | 3/4, 1 and 1 1/4 " | |
| Spindle Size Under Nut | 3/4 (3 1/2), 1 (6 1/4) and 1 1/4 (6 1/4) " | |
| Spindle Travel | 7 | |
| Tilting Spindle | 45° forward, 5° back | |
| Table Size | 51 1/2 x 33 1/2 " | |
| Fence Size (L x H) | 46 x 5 " | |
| Fence Travel (Major and Minor) | 5 3/8 and 3 5/8 " | |
| Slide Table Size (L x W) | 11 1/4 x 51 1/4 " | |
| Table Travel | 49 1/4 " | |
| Table Inserts | one tilting, two straight | |
| Maximum Diameter Cutter Below Table | 9 | " |
| Maximum Diameter Cutter Above Table | 12 | " |
| Router Bit Collet Diameter | 1/4 and 1/2 " | |
| Dust Port Outside Diameter | 5 " (dual ports) | |
| Dust Collection Minimum CFM Required | 800 | cu.ft/min |
| Electrical Controls - Magnetic Starter | Yes | |
| Motor Power | 7½ | HP |
| Motor Voltage | 230 / 460 V | |
| Prewired Voltage | 230 | V |
| Motor Phase | 3 | Ph |
| Model Number | TS29 | |
| Brand | Powermatic | |
| Overall Dimensions | 51 x 44 x 53 | |
| Height | 53 | inch |
| Width | 44 | inch |
| Length | 51 | inch |
| Net Weight | 1100 | pound |