The DP-1250VS-HS is a high speed version of the DP-1250VS from Baileigh Industrial. The reason for the high speed is to allow any shop to enjoy the process of thermal friction drilling. This is a unique process in which a bit actually melts through the material and creates “walls” that can then be tapped. But in order to use this process, the bit must be turning more than 3000 rpm. This is where the DP-1250VS-HS high speed drill press comes in.
****Baileigh Industrial now carries a full line of thermal friction drills and taps!!!!
The DP-1250VS-HS shares all the exact same features as its brother and would be perfect for anybody looking to upgrade their current drill. The DP-1250VS-HS from Baileigh Industrial is a 20” drill press that has a capacity of 1-1/4” mild steel. It uses 220 volt single phase power to run a Delta® inverter. The inverter regulates the amount of power and rpms to the spindle. Using an inverter to drive its massive mt4 spindle gives the DP-1250VS-HS the ability to set rpm to an exact speed; from 0 to 4000. It also has a quality auto reversing tap feature.
The DP-1250VS-HS uses a heavy duty cast iron base that has a coolant system built right in. The DP-1250VS-HS also has a 4-1/2” wide column that was designed to minimize the flex. The work table has been machined, polished and has t-slots for your work holding device.
Other features include an mt4 taper and chuck, a spindle safety shield with limit switch and halogen work light. Contact a Baileigh Industrial representative for more information on the DP-1250VS-HS high speed drill press or if you have question about thermal friction drilling, today.
|Spindle Nose to Table
|Spindle Nose to Base
|Spindle Speed High
||245 - 4000 rpm
|Spindle Speed Low
||100 to 1070 rpm
||220V / 1-phase
|Base Dimensions L x W
||27" x 19"
||40" x 25" x 83"